In addition to using dehumidifiers. Fortunately, we will help you prevent - remove mold for your toilet, bathroom with just 3 ways.
1- Improving light and ventilation
- Improving ventilation and lighting is an important first step in getting rid of your mold problem. Keep windows and doors open as much as possible and put a vent fan on to remove steam while showering.
To improve bathroom lighting, remove blinds and curtains and replace opaque glass. Take advantage of sunlight by using mirrors to reflect the sun into the toilet, the bathroom.
2- Remove mold on bricks and walls.
Step 1: You need to buy Javen bleach. Javen bleach is one of the fastest, most effective and least effective anti-microbial agents, this Javen bleach is also a familiar product to bleach girls' tunic here. You also need to buy a small lottery roller.
Step 2: You get a broom (preferably a straw broom), wipe out the area of the molded wall. Then pour bleach water into Javen small brass, dip Lot tree to paint into bleach, then roll evenly on the molded wall. Note: Do not pour too much bleach into the brass, because it will make the Lot tree soaked with bleach, when rolling the lot on the wall, it may be dropped on the floor, the smell of Javen bleach is very uncomfortable. Each liter of bleach water can roll about 10m2. You remember wearing a mask and glasses to avoid the bad smell and tear of the Javen bleaching water. If the bleached water drops on other utensils, wash and clean immediately.
Step 3: Open all door windows in the room to remove mold. After rolling all molded positions, turn on the largest digital fan so that the wind direction blows out the door to quickly remove the smell. Note that this type of bleach is very strong, so just roll a thin layer is out of mold immediately, if rolling a lot of bleach on the wall will very long run out of smell. If after one day the test is still not finished, it can be done in one of two ways:
Method 1: Mix a large bowl of salt water, or interrupt about a dozen betel leaves without soaking in the big water to enter the room, about an hour later will run out of smell.
Method 2: If the house has a deodorizer or food detox machine with both Ozon and Ion modes, turn on the machine via Ion mode and close the door, about 30 minutes to an hour, make sure the smell is gone.
3- Remove mold by vinegar
Tools you need to prepare include: Latex gloves, white vinegar, spray, soap, water, floor scrubbing table
Step 1: Wear gloves. Distilled white vinegar is safe, non-toxic and organic, but can cause skin irritation. To protect your hands from the harmful effects of vinegar acids and from the irritating effects of mold, wear rubber gloves.
Step 2: Clean. Use soap, water and a hard brush, scrub the mold area until mold is removed. Soap and water are very effective in removing mold
Step 3: Kill fungi. Pour vinegar into the spray bottle and spray on the place where the mold is. Clean the mold with a hard brush. Then let it dry and repeat the same steps until the mold is completely clean.